Pioneer RS-A99, Owner'S Manual

Page: 15 / 16

Specifications
Power source ............................. 14.4 V DC (10.8 V to 15.1 V
allowable)
Grounding system ................... Negative type
Current consumption ............ 27 A (at continuous power,
4
W
)
3 A (No signal)
Average current drawn ......... 9 A (4
W
for four channels)
9 A (4
W
for two channels)
Fuse ................................................ 25 A × 2
Dimensions (W × H × D) ... 258 mm × 63 mm × 360
mm
Weight .......................................... 8.3 kg
Maximum power output ....... 100 W × 4 (4
W
) / 300 W × 2
(4
W
)
Continuous power output ... 50 W × 4 (at 14.4 V, 4
W
, 20
Hz to 20 kHz, 0.08 %)
150 W × 2 (at 14.4 V, 4
W
, 20
Hz to 20 kHz, 0.8 %)
75 W × 4 (at 14.4 V, 2
W
, 20
Hz to 20 kHz, 0.8 %)
Load impedance ...................... 4
W
(2
W
to 8
W
allowable)
Frequency response ............... 10 Hz to 100 kHz (+0 dB, -1
dB)
Signal-to-noise ratio ............... 108 dB (IEC-A network)
Distortion ..................................... 0.002 % (1 W, 1 kHz)
Separation .................................. 85 dB (100 Hz to 10 kHz, 20
kHz LPF)
Slew rate ...................................... 100 V / µ sec.
Damping factor ........................ 130
Level adjustment (Gain control)
..................................................... ±3 dB (L/R independent)
Maximum input / Continuous input
RCA ...................................... 10 V / 2.5 V
(Super high-voltage mode
on)
Input impedance ..................... 5 k
W
(Super high-voltage
mode on)
22 k
W
(Super high-voltage
mode off)
Notes
!
Specifications and the design are subject to
modifications without notice.
!
The average current drawn is nearly the maxi-
mum current drawn by this unit when an
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.
En
15
Appendix
Additional
information
Additional information