<CRD4227B> 4
3
Setting the Unit
ENG/MASTER 96
Terminal Cover
Before setting up the unit, unfas-
ten the screws with a 4 mm
hexagonal wrench and remove
the terminal cover.
Bass Boost Level Control
You can select a bass boost level from
0, 6, 9 and 12 dB.
For instruction of connecting the bass
boost remote control to the amplifier,
see the “Connection Diagram” section.
MODE SELECT Switch
You can select amplifier’s sync mode from
MASTER, SYNC and SYNC INV. Set the
MODE SELECT switch to the MASTER posi-
tion when using one amplifier only. When using
synchronously connecting two or more of these
amplifiers in combination, set the first amplifier
to MASTER, and set the remaining amplifiers to
SYNC or SYNC INV according to the manner in
which they are connected. The only time the
amplifier is switched to the SYNC INV mode is
when amplifiers are synchronously connected
with the ex. bridge.
When switching to the SYNC or SYNC INV
mode, remove the screw and stopper. Remove
the screw and stopper after checking that
connections are correct. See the “Connecting the
Speaker Wires” section for details on the MODE
SELECT switch.
Cut Off Frequency Control
for LPF
You can select a cut off frequency
from 40 Hz to 240 Hz.
Bass Boost Frequency Control
You can select a bass boost frequency
from 40 Hz to 120 Hz with the bass
boost control.
1_CRD4227B_Eng 2009.11.12 1:14 PM Page 4
