Pioneer PDP-R05E, Service Manual

Page: 156 / 213

PDP-R05E
156
1 2 3 4
1 2 3 4
C
D
F
A
B
E
6.8 LIST OF RS-232C COMMANDS
RS-232C commands can be used in Service Factory mode.
Before using RS-232C commands, it is necessary to change the factory presetting. See "6.3. USING RS-232C COMMANDS."
Command Operation Remarks
A
ABL Adjusting power consumption
B
BCP Transmitting the backup data to the DIGITAL Assy
BAVS00 Setting the power supply for the DTB antenna to 0 V
BAVS02 Setting the power supply for the DTB antenna to 5 V
BSL Adjusting side mask B
BYG BY GAIN
C
CNG Clearing MR NG information
CPC Clearing the power-on counter
CPD Clearing power-down information
CSD Clearing shutdown information
CTM Clearing the modification log
D
OSDS01 Turning on the on-screen display While the OSDSOI command is in force, the duration of on-screen display is unlimited.
OSDS00 Turning off the on-screen display On-screen display is prohibited.
DRF Turning off the power for the drive system
DRN Turning on the power for the drive system
DW* Decreasing the adjustment value by * *: 1-9, 0 (0 means 10), or F (making the adjustment value the minimum)
E
EDWS00 Prohibiting writing of EDID data
EDWS01 Permitting writing of EDID data
F
F50 Video 50-Hz sequence
F60 Video 60-Hz sequence
F61 PC 60-Hz sequence
F70 PC 70-Hz sequence
F72 Video 72-Hz sequence
F75 Video 75-Hz sequence
FAY Turning Service Factory mode on
FAJ Determining the adjustment values for the unit
FAN Turning Service Factory mode off
Focus OFF
Focus ON
Final set up
FCSS00
FCSS01
FST
The GUI equivalent to that usually displayed when the power is turned on is displayed.
G
The GET-group commands are effective at any time, including during Standby mode.
GAJ Obtaining the adjustment values for the panel
GDI Command to obtain Status
GA2 Obtaining the various adjustment values (Add Vrn to GAJ)
GMM Switching the gamma levels Setting value: 000-007
GNG Obtaining NG data of the MR
GNM Obtaining the serial No. of the MR
GNP Obtaining the serial No. of the panel
GPC Obtaining the P ON COUNTER value
GPD Obtaining power-down information
GPR Obtaining the PANEL REVISE data
GPM Obtaining the PULSE METER data
GPW Obtaining the PANEL W/B data
GS1 Obtaining the version data for each device
GS2 Obtaining data on various operations
GS6 Obtaining the any version
GSD Obtaining shutdown information
Adjusting side mask G
GYG GY GAIN
GSL
CHM Clearing the hour meter
CPM Clearing the pulse meter
This command is effective even during Standby mode.
PDP-R05XE only
PDP-R05XE only