Pioneer PDP-R05E, Service Manual

Page: 138 / 213

PDP-R05E
138
1 2 3 4
1 2 3 4
C
D
F
A
B
E
6.6 SERVICING USING ONLY THE MEDIA RECEIVER
For servicing of the PDP-435HD and PDP-505HD-series Plasma Display using only the Media Receiver, the following two
methods can be used:
¶
Remote controlling using SR connections (Except PDP-R05FE)
About connections
• Connect the SR OUT connector of a Pioneer product having that connector (a DVD in the following example) and the SR IN connector of the
Media Receiver, using the SR cable. As the remote control sensor is not provided with the Media Receiver, this connection is required for
using the remote control unit if the panel is not available. In this case, aim the remote control unit at the remote control sensor of the device
(DVD in this case).
• Connect either the audio or the video output of the device (DVD in the example) and the corresponding audio or video input of the Media
Receiver, using a cable with phono plugs. This connection is required in order to use ground in common with the SR cable, because with the
SR cable connection the ground connection for signal reference is not available. In the example, the audio L channel is used, but the audio
R channel or video can be used instead.
• If the plasma display for a previous model, such as the PDP-433P or PDP-503P, is available, servicing while checking displays or using the
menus is possible. For this, connect only the DVI connectors (white) of the Media Receiver and the plasma display. The MDR connector of
the Media Receiver must not be used, even though it has the same shape and number of pins, because signals assigned to the connectors
differ. Using the MDR connector may damage the unit.
¶
RS-232C control using a PC
In this case the setting is RS-232C 38400bps, and the setting of "6.3. USING RS-232C COMMANDS" is not related.
Please set baud rate of PC in 38400bps.
For connection with the PC, use a straight cable.
¶
Note on connection
If the MDR connector of the PDP-434HD or -504HD-series is used, it is considered that the PDP-434P (or -504P) is connected, and the Media
Receiver operates on such precondition,
which may result in a failure of the Media Receiver. Be sure not to connect to the MDR
connector. (Do NOT use the MDR connector when servicing the Media Receiver alone.)
OUTPUT
VIDEO L R SR OUT
Pioneer product having the
SR OUT connector (DVD, etc.)
SR cable
(monaural cable)
Pin cable Use only the DVI (white) connectors.
(Do NOT use the MDR connectors.)
Media Receiver (this unit)
Media Receiver (this unit)
Media Receiver (this unit)
If the PDP-433P (or PDP-503P) is
available, servicing while checking
displays or using the menus is possible.
INPUT 1
VIDEO L R
MDR
AC IN
DVI
SR IN 232C
Use only the DVI (white) connectors.
(Do NOT use the MDR connectors.)
232C
PC (having a serial port)
Serial cable
(9-pin, straight)
If the PDP-433P (or PDP-503P) is
available, servicing while checking
displays or using the menus is possible.
INPUT 1
VIDEO L R
MDR
AC IN
DVI
SR IN 232C
PDP-504P (or -434P)
PDP-505P (or -435P)
NO
OK
PDP-503P, etc.
INPUT 1
VIDEO L R
MDR
AC IN
DVI
SR IN 232C