PDP-434CMX
62
1
2
3
4
1
2
3
4
C
D
F
A
B
E
6. ADJUSTMENT
6.1
ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
43 Y DRIVE Assy
No adjustment required
AV I/O Assy
No adjustment required
RGB Assy
No adjustment required
POWER SUPPLY Unit
No adjustment required
DIGITAL VIDEO Assy
Refer to the "7.1.6 BACKUP THE ADJUSTMENT VALUES
FOR THE MAIN UNIT."
43 X DRIVE Assy
No adjustment required
VIDEO SLOT Assy
Other assemblies
No adjustment required
No adjustment required
Service Panel
VSUS and VOFS voltage setup, Panel WB check
POWER SUPPLY Unit
DIGITAL VIDEO Assy
No adjustment required
43 X DRIVE Assy
Replacement and repair of IC1101 and IC1102 are
impossible.
43 Y DRIVE Assy
Replacement and repair of IC2201 and IC2202 are
impossible.
Replacement and repair of IC7610 and IC8705 are
impossible.
AV I/O Assy
RGB Assy
Replacement and repair of IC6001, IC6401, IC6403,
IC6601, IC6602 and IC7205 are impossible.
Replacement and repair of IC6107, IC6255, IC6257
and IC7902 are impossible.
VIDEO SLOT Assy
Other assemblies
No adjustment required
When any of the following assemblies is replaced
When any part in the following assemblies is replaced
The assembly must be replaced as a unit, and no part
replacement is allowed.