Notes
!
If
SPEANA
(spectrum analyzer) is selected,
the spectrum analyzer will be displayed in-
stead of Source image display or Artwork dis-
play.
!
If you select
USB
,
SD
as the source, you can-
not select
Slide Show
.
Customizing the illumination color
1
Use M.C. to select Color Setting in the
Appearance (Illumination color).
Refer to
2
Use M.C. to customize the color.
Turn for fine tuning. Push left or right to adjust
the next color.
3
Press M.C. to store the customized color
in the memory.
The illumination color will be switched to the
customized color.
Initial Settings
1
Press and hold SRC/OFF until the unit
turns off.
2
Press M.C. to display the initial setting
menu.
3
Turn M.C. to select the initial setting.
After selecting, perform the following proce-
dures to set the initial setting.
A-EQ Measurement
(auto-equalizing)
The auto-equalizer is an equalizer curve created by
auto EQ (refer to
page).
You can turn the auto-equalizer on or off.
Rear Speaker
(rear output and subwoofer setting)
This unit
’
s rear output (rear speaker leads output and
RCA rear output) can be used for full-range speaker
(
Full
) or subwoofer (
Subwoofer
) connection. If you
switch the rear output setting to
Subwoofer
, you can
connect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker con-
nection (
Full
).
1
Press
M.C.
to display the setting mode.
2
Turn
M.C.
to change the setting.
Subwoofer
(subwoofer)
—
Full
(full-range speak-
er)
!
Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to
!
If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
3
Press
M.C.
to confirm the selection.
Demonstration
(demo display setting)
1
Press
M.C.
to turn the demo display on or off.
BT Memory Clear
(resetting the Bluetooth wireless
technology module)
En
35
English
Section
03
Operating this unit
Summary of Contents for MVH-P7300
Page 187: ...Es 187 Español ...