Pioneer KURO PDP-LX508D, Service Manual

Page: 108 / 175

PDP-LX5080D
108
1 2 3 4
1 2 3 4
C
D
F
A
B
E
6.2.4 INITIALIZE
N I I T I L A I Z E
I D S E M A S L L + ( ) K
I N
E V E
A – V 1 3 1 0 6 0 – N T V H E – B 1
5
10
15
16
1 5 10 15 20 25 30 35 40
To configure sidemask level (To adjust the values, input signal is required).
• To reset each memory values to factory default values. Factory command is "FST".
•
W hen the configuration is set to < N O> and the [E N TER/SET] key is pressed, no action is taken and the menu returns to
previous screen.
•
W hen the configuration is set to <YES> and the [E N TER/SET] key is pressed for 5 seconds, the reset action executes.
Display Content RS-232C
SIDE MASK LE V EL <=> Adjust Side Mask level (Adjustable range: 000 to 255) SML
N I I T I L A I Z E
A T D A R E S T E
I N F A L S E T U P
< = >
A – V 1 3 1 0 6 0
O
: N
– N T V H E – B 1
5
10
15
16
1 5 10 15 20 25 30 35 40
6.2.4.2 FINAL SETUP (+)
6.2.4.1 SIDE MASK LEVEL (+)
6.2.4.3 Wide XGA AUTO <=>
Be sure to disconnect and connect the AC cable after FINAL SETUP.
When replacing the MAIN Assy, the FINAL SETUP is re
q uired.
Exclusively used for technical analsyis (details omitted).
Operation item
No. Function Content RS-232C
6.2.4.1 SIDE MASK LE V EL (+) Configure the color of the side mask. SML
6.2.4.2 FI N AL SETUP (+) Initialize flash memorys on virgin product status FST
6.2.4.3 W ide XGA AUTO <=> Exclusively used for technical analsyis.
−−−
To ensure proper function of the product, leave the AC cable unplugged for 1 minute or more before plugging it again.
If the AC cable is plugged back in immediately after unplugging, software for the DT
V block may not start up properly.