Preparation
05
15
En
Preventing the flat screen TV from falling over
After installing the stand, be sure to take special care to ensure that the flat
screen TV will not fall over and is stabilised to both the wall and rack.
Stabilising on a table or rack
Stabilise the flat screen TV as shown in the diagram using the falling prevention
metal fittings and screws supplied with the optional stand.
Note
• Before stabilising the flat screen TV on a stand or rack, make sure that the
falling prevention metal fittings are attached to the stand.
• To stabilise the flat screen TV on a table or rack, also use commercially
available wood screws that have a nominal diameter of 4 mm and that are at
least 20 mm long.
Drill a hole in the middle at the rear of the tabletop panel before using a wood
screw. Perform this work the same way on the left and right sides.
Drill a hole in the middle at the rear of the tabletop panel before using a wood
screw. Perform this work the same way on the left and right sides.
Using a wall for stabilisation
1
Attach falling prevention bolts (hooks) to the flat screen TV.
2
Use strong cords to stabilise it appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right sides.
Use hooks, cords and fittings that are available on the market. Recommended
hook: Nominal diameter 8 mm, length 12 mm to 18 mm
(PDP-LX609A)
8 m
m to 15 m
m
20 mm min.
4 mm
Wood screw
(commercially available,
4 mm x 20 mm min.)
(PDP-LX509A)
8 mm to 15
mm
20 mm min.
4 mm
Wood screw
(commercially available,
4 mm x 20 mm min.)
1. Hook
2. Cord
Fitting
12 mm to 18 mm
M8
