Pioneer Elite VSX-32, Operating Instructions Manual

Page: 89 / 112

Additional information 12
89
En
Positional relationship between speakers
and monitor
Position of front speakers and monitor
The f r ont s p eake r s should be as equidistant as p ossible
to the monito r .
Position of center speaker and monitor
Since mostly dialogs a r e out p ut f r om the cente r s p eake r ,
kee p ing the cente r s p eake r as close as p ossible to the
sc r een makes the ove r all sound mo r e natu r al. Fo r TVs
using B r aun tubes, howeve r , when installing the cente r
s p eake r on the floo r , adjust its angle of elevation to p oint
it towa r ds the listening p osition.
• If the cente r s p eake r is not of the shielded ty p e, install
it away f r om the TV.
• When installing the cente r s p eake r on to p of the
monito r , p lace it facing slightly downwa r ds towa r ds
the listening p osition.
Troubleshooting
Inco rr ect o p e r ations a r e often mistaken fo r t r ouble and malfunctions. If you think that the r e is something w r ong with
this com p onent, check the p oints below. Sometimes the t r ouble may lie in anothe r com p onent. Investigate the othe r
com p onents and elect r ical a pp liances being used. If the t r ouble cannot be r ectified even afte r exe r cising the checks
listed below, ask you r nea r est Pionee r autho r ized inde p endent se r vice com p any to ca rr y out r e p ai r wo r k.
Note
• If the unit does not o p e r ate no r mally due to exte r nal effects such as static elect r icity disconnect the p owe r p lug
f r om the outlet and inse r t again to r etu r n to no r mal o p e r ating conditions.
Power
TV
L R
45° to 60°
Installation on floo r (Diag r am as seen
f r om the side)
Monito r
Symptom Remedy
The p owe r does not tu r n on. • Make su r e that the p owe r co r d is p lugged in to an active p owe r outlet.
• T r y disconnecting f r om the p owe r outlet, then p lugging back in.
Powe r cannot be tu r ned off.
( ZONE 2 ON o r ZONE 3 ON
(VSX-33 only) is dis p layed.)
• Set the r emote cont r ol’s
MULTI-ZONE
o p e r ation selecto r switch to
ZONE 2
o r
ZONE 3
(VSX-33
only), then pr ess 
RECEIVER
to switch the sub zone off.
The r eceive r suddenly switches
off o r the iPod iPhone
indicato r blinks.
• Check that the r e a r e no loose st r ands of s p eake r wi r e touching the r ea r p anel o r anothe r set of
wi r es. If so, r e-attach the s p eake r wi r es, making su r e the r e a r e no st r ay st r ands.
• The r eceive r may have a se r ious pr oblem. Disconnect f r om the p owe r and call a Pionee r autho r ized
inde p endent se r vice com p any.
Du r ing loud p layback the
p owe r suddenly switches off.
• Tu r n down the volume.
• Lowe r the 63 Hz and 125 Hz equalize r levels in the Manual MCACC setup on p age 75.
• Switch on the digital safety featu r e. While holding down ENTER on the f r ont p anel, pr ess

STANDBY/ON
to set this r eceive r to the standby mode. Use
TUNE
/
to select
D.SAFETY

OFF
 , and then use
PRESET
/
to select
1
o r
2
(select
D.SAFETY

OFF
 to deactivate this
featu r e). If the p owe r switches off even with 2 switched on, tu r n down the volume. With 1 o r 2 on,
some featu r es may be unavailable.
The unit does not r es p ond
when the buttons a r e pr essed.
• T r y switching the r eceive r off, then back on again.
• T r y disconnecting the p owe r co r d, then connect again.
VSX-33_UXJCB.book 89 ページ ２０１０年３月９日 火曜日 午前１０時３９分