30
03
Connecting your equipment
Connecting additional amplifiers
This receiver has more than enough power for any home use, but it’s possible to add additional amplifiers to every
channel of your system using the pre-outs. Make the connections shown below to add amplifiers to power your
speakers.
PRE OUT
SUBWOOFER
1
2
SURROUND SURR BACK FH / FW
(Single)
FRONT
CENTER
L
R
PRE OUT
SUBWOOFER
1
2
SURROUND SURR BACK FH / FW
(Single)
FRONT
CENTER
L
R
R
L
ANALOG
INPUT
R
L
ANALOG
INPUT
R
L
ANALOG
INPUT
ANALOG
INPUT
ANALOG
INPUT
R
L
ANALOG
INPUT
Front channel
amplifier
Center channel
amplifier (mono)
Surround
channel amplifier
Front height or Front wide
channel amplifier
Surround back
channel amplifier
Powered
subwoofer 1
ANALOG
INPUT
Powered
subwoofer 2
!
If you’re not using a subwoofer, change the front speaker setting (see
Speaker Setting
on
page 81
) to
LARGE
.
!
You can use the additional amplifier on the surround back channel pre-outs for a single speaker as well. In this
case plug the amplifier into the left (
SURROUND BACK L (Single)
) terminal only.
!
The sound from the surround back terminals will depend on how you have configured the
Speaker system set-
ting
on
page 85
.
!
If you have two subwoofers, the second subwoofer can be connected to the
SUBWOOFER 2
terminal.
Connecting two subwoofers increases the bass sound to achieve more powerful sound reproduction. In this
case, the same sound is output from the two subwoofers.
!
To hear sound only from the pre-outs, switch the speaker terminals to
SP:
OFF
(
page 67
) or simply disconnect
any speakers that are connected directly to the receiver.
Connecting AM/FM antennas
Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality,
connect external antennas (see
Connecting external antennas
on
page 31
).
ANTENNA
AM LOOP
FM UNBAL 75
ANTENNA
AM LOOP
FM UNBAL 75
1
4
5
2
3
a
b
c
1 Pull off the protective shields of both AM antenna wires.
2 Push open the tabs, then insert one wire fully into each terminal, then release the tabs to
secure the AM antenna wires.
3 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction indicated by the arrow (
fig. a
) then clip the loop onto the
stand (
fig. b
).
!
If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (
fig. c
) before
clipping the loop to the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface and in a direction giving the best reception.
5 Connect the FM wire antenna into the FM antenna socket.
For best results, extend the FM antenna fully and fix to a wall or door frame. Don’t drape loosely or leave coiled up.
