En
gl
ish
- 41 -
[Steering Wheel Control]
[With Adapter], [W/o
Adapter]
Select [With Adapter] or [W/o Adapter] according to your
wired remote control.
NOTES
•
This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
•
Depending on your vehicle, this function may not work
properly. In this case, contact your dealer or an authorised
PIONEER Service Station.
•
Please use a PIONEER wiring harness for each car model when
[With Adapter] mode is engaged, otherwise select [W/o
Adapter].
[Radio settings]
[Factory Reset]
Touch [OK] to restore the settings to the default settings.
CAUTION
Do not turn off the engine while restoring the settings.
NOTES
•
This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
•
The source is turned off and the Bluetooth connection is
disconnected before the process starts.
•
Before starting the restore process, disconnect any device that is
connected to the USB port. Otherwise, some settings may not
be restored correctly.
[Connection Status]
Check that the leads are properly connected between this
product and vehicle.
[GPS Antenna]
Displays the connection status of the GPS aerial ([OK] or
[NOK]) and the reception sensitivity.
NOTE
If reception is poor, change the installation position of the GPS
aerial.
[Positioning Status]
Displays the positioning status (3D positioning, 2D
positioning, or no positioning), the number of satellites
used for positioning (orange), and the number of satellites
that have received signals (yellow). If signals from more
than six satellites are received, the current location can be
measured.
Menu Item
Description
