En
30
Changing the settings
Replacing the bumper in the crossfader section
Be sure to follow the directions for safe use of the product.
Note that the part replacement of this unit should be done on your responsibility.
Caution
!
Turn off the power of the unit before starting the work.
!
Never turn on the power of the unit until the work is completed.
!
Never touch areas other than the indicated ones.
!
Never use parts other that the supplied ones.
!
Take care not to drop the removed parts inside the unit.
!
Do not work with wet hands.
!
Do not work with liquids placed nearby.
!
Do not work in a place where this unit may come into contact with
liquids.
Caution
Perform the replacement with attention to the following.
!
Work in a flat and non-slip place.
!
Do not work in a dusty place.
!
Store the removed parts in a safe place until the installation.
!
Keep small parts out of the reach of children and infants. If acciden-
tally swallowed, contact a doctor immediately.
!
If parts fell inside the unit and cannot be taken out, never turn on the
power and pull out the power plug, and then contact a service center
to request repairs.
Disclaimer
!
The replacement should be done on your own responsibility. Read
the descriptions on this booklet carefully and perform the operation
with caution.
!
Note that we will accept no responsibility whatsoever for any loss or
damage resulting from the replacement.
!
Replacement parts for the parts lost or damaged during replacement
have to be paid even within the warranty period.
!
If malfunctions, damages or any other conditions that require repair
occur with this product resulting from the replacement, the repair
has to be paid even within the warranty period. (The unit may not be
able to be repaired depending on the damaged condition.)
1 Turn off the power of this unit.
2 Remove the controls.
Remove the seven controls shown in the diagram below.
1
2
3
4
5
6
7
1
to
3
Rotary control
4
Fader control (small)
5
to
7
Fader control (large)
!
The rotary controls and fader control (small) are attached by inser-
tion. Pull them out upward. If it is hard to pull them out, wrap them
with something that does not slip and pull them out.
!
The fader controls (large) consist of the following parts.
Fader control (large) (indicating line part)
Fader control (large) (control part)
Fader control (large) (base part)
!
Refer to the diagram below for disassembling the fader control
(large).
1
2
3
4
1
Lift the bottom edge of the indicating line part with a fine-tipped
tool.
—
Lift the side that the bottom edge of the indicating line part
extends to the bottom of the control part.
2
Pull out the indicating line part upward.
3
Pull out the control part upward.
4
Pull out the base part to the side.
3 Remove the screws using a screwdriver.
Remove the six screws shown in the diagram below.
