En
26
Controlling the Serato DJ software
Here we explain three types of connections for different usage environments.
!
When using analog players, proceed to page 26 .
!
When using DJ players, proceed to page 27 .
!
When using analog players and DJ players simultaneously, proceed to page 28 .
When using analog players
The following describes how to use the unit by connecting analog players to the Serato DJ software’s decks from [
DECK1
] to [
DECK4
].
To amplifier
L R
L R
Computer
To power outlet
Audio cable
Audio cable
Ground wire
Ground wire
CONTROL VINYL
CONTROL VINYL
Analog player
Analog player
1 Connect the analog player used to control [DECK1]
and [DECK3] to the [PHONO] terminals of [CH1], and the
analog player used to control [DECK2] and [DECK4] to
the [PHONO] terminals of [CH2].
2 Connect the ground wires for the respective analog
players to this unit’s [SIGNAL GND] terminals.
3 Set the control vinyls on the analog players.
4 Switch the DJM-S9’s input.
Set the [
INPUT SELECT
] switches of [
CH1
] and [
CH2
] to the [
] side.
[
INPUT SELECT
]
switch
5 Select [SETUP] on the Serato DJ software’s screen,
then select [TURNTABLES] at the [Audio] tab in the utility
settings.
