- 6 -
En
g
lis
h
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
•
Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine,
fire or the like.
CAUTION
•
There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type.
•
Do not handle or store the battery with metallic tools or objects.
•
If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
•
When disposing of used batteries, please comply with governmental regulations or environmental
public institution’s rules that apply in your country/area.
•
“Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)”
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the
M.C.
dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the
M.C.
dial to select [NO], then press to confirm.
2
Turn the
M.C.
dial to adjust the hour, then press to confirm.
The indicator moves to the minute setting automatically.
3
Turn the
M.C.
dial to adjust the minute, then press to confirm.
[QUIT] appears.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
NOTES
•
You can cancel the menu setting by pressing
SRC/OFF
.
•
This setting can be made at any time. See page 14 for more details.
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [SYSTEM], then press to confirm.
Setting the clock (CLOCK SET)
Canceling the demonstration display (DEMO OFF)
