8
English
Español
Deutsch
Français
Italiano
Nederlands
Dashboard
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Rubber bush
Screw
DIN Front-mount
Installation with the rubber bush (Fig. 6)
Fig. 6
Removing the Unit (Fig. 7)
Fig. 7
182
53
Frame
To remove the frame, extend top and
bottom of the frame outwards in order
to unlock it. (When reattaching the
frame, point the side with a groove
downwards and attach it.)
• It becomes easy to remove the
frame if the front panel is released.
Insert the supplied extraction keys
into the unit, as shown in the figure,
until they click into place. Keeping
the keys pressed against the sides of
the unit, pull the unit out.
Frame
