Pioneer DEH-6400BT, Operation Manual

Page: 16 / 36

The cut-off frequency and output level can be ad-
justed when the subwoofer output is on.
Only frequencies lower than those in the selected
range are outputted from the subwoofer.
1
Press M.C. to display the setting mode.
2
Press M.C. to cycle between the cut-off frequency
and the output level for the subwoofer.
3
Turn M.C. to select the cut-off frequency.
50Hz
—
63Hz
—
80Hz
—
100Hz
—
125Hz
4
Turn M.C. to adjust the output level for the sub-
woofer.
The subwoofer level increases or decreases each
time you turn
M.C. +6
to
–
24
is displayed as the
level is increased or decreased.
Bass Booster (bass boost)
1
Press M.C. to display the setting mode.
2
Turn
M.C.
to select a desired level.
0 to +6 is displayed as the level is increased or de-
creased.
HPF (high pass filter adjustment)
When you do not want low sounds from the subwoo-
fer output frequency range to play from the front or
rear speakers, turn on the HPF (high pass filter). Only
frequencies higher than those in the selected range
are output from the front or rear speakers.
1
Press M.C. to display the setting mode.
2
Press M.C. to turn high pass filter on or off.
3
Turn M.C. to select the cut-off frequency.
50Hz
—
63Hz
—
80Hz
—
100Hz
—
125Hz
SLA (source level adjustment)
SLA (Source level adjustment) lets you adjust the vo-
lume level of each source to prevent radical changes
in volume when switching between sources.
!
When selecting FM as the source, you cannot
switch to
SLA .
!
Settings are based on the FM volume level, which
remains unchanged.
!
The MW/LW volume level can also be adjusted
with this function.
1
Press M.C. to display the setting mode.
2
Turn
M.C.
to adjust the source volume.
Adjustment range: +4 to
–
4
Using Bluetooth wireless
technology
Using Bluetooth telephone
Important
!
Since this unit is on standby to connect with
your cellular phone via Bluetooth wireless
technology, using it without the engine run-
ning can drain the battery power.
!
Operations may vary depending on the kind of
cellular phone.
!
Advanced operations that require attention
such as dialing numbers on the monitor,
using the phone book, etc., are prohibited
while driving. Park your vehicle in a safe place
when using these advanced operations.
Setting up for hands-free phoning
Before you can use the hands-free phoning
function you must set up the unit for use with
your cellular phone.
1
Connection
Operate the Bluetooth telephone connection
menu. Refer to
Connection menu operation on the
next page.
2
Function settings
Operate the Bluetooth telephone function menu.
Refer to
Phone menu operation on page 19.
Basic operations
Making a phone call
!
Refer to Phone menu operation on page 19.
Answering an incoming call
1
When a call is received, press M.C.
Ending a call
1
Press
PHONE
.
Rejecting an incoming call
1
When a call is received, press PHONE .
Answering a call waiting
1
When a call is received, press M.C.
Switching between callers on hold
1
Press
M.C.
En
16
Section
02
Operating this unit