66
CDJ-1000
7.1.4 Part Replacement Method of JOG Section
7.1.4.1 A part to Replace in Part Replacement Simultaneously
7.1.4.2 Caution in Sheet SW Installation
Note : Do not need to replace the JOG Holder when replacing the Sheet SW. However, be careful so that paste
does not remain on the former Sheet SW.
JOG Holder
JOG Sheet A
JOG Dial B
Encoder Plate
JOG Dial A
JOG Plate
JOG Panel
JOG Sheet C
(
JFLB Assy
Sheet SW
Fig.
Ÿ
Fig. 1 JOG Section View
Fig.
!
(Bottom View)
1
Be careful not to bend and fold the Sheet SW.
2
Confirm that the dust or trash does not adhere to pasting side
(JOG Holder).
In addition, when tear off the former Sheet SW and put a new
part, completely wipe the JOG Holder off with alcohol so that
paste does not remain on the pasting side of JOG Holder.
3
Bend a cable of the Sheet SW in a right angle in difference in
grade shape, and put it in corner hole of the JOG Holder.
(Fig.
Ÿ
)
4
When put the Sheet SW, match the position not to run aground
on rib of the internal circumference of JOG Holder. (Fig.
Ÿ
)
5
Sheet SW pushes all the sides including the point of contact
fully, and put it. (No good air getting into it.)
6
When insert a cable in connector, release a lock by all means,
and connector locks after inserting it.
7
A cable performs styling as shown in Fig.
!
after installing the
JFLB Assy (DWG1549).
3
Replacement Part
Sheet SW
(DSX1057)
JOG Sheet A
(DXB1757)
JOG Sheet B
(DXB1757)
JOG Sheet C
(DXB1757)
JOG Plate
(DAH2052)
JOG Holder
(DNK3872)
JOG Dial A
(DNK3870)
JOG Dial B
(DNK3871)
A Part to
Replace
Simultaneo-
usly
Sheet SW
JOG Sheet A
JOG Sheet B
JOG Sheet C
JOG Plate
JOG Holder
JOG Dial A
JOG Dial B
4
7
8
It assembles so that an encoder plate may go into the slot of the
encoder guide of JOGB Assy.
JOGB ASSY
encoder plate
encoder guide
[ Sectional view ]
JOGB ASSY
JOGB ASSY
Encoder plate
Encoder guide
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
