Pioneer BDP-3120, Operating Instructions Manual

Page: 6 / 48

01
6
Chapter 1
Check the Accessories
• Remote control unit x 1
• AAA/R03 size battery x 2
• Power cord x 1
• Software license notice
• Operating instrusctions (this document)
Prepare the remote control
1. Open the battery compartment.
2. Insert 2 batteries (AAA/R03 size battery
)
with correct polarity (
/ ) as indicated.
3. Close the battery compartment.
Notes:
• Do not use any battery other than the ones
specified. Also, do not use a new battery
together with an old one.
• When loading the batteries into the remote
control, set them in the proper directin, as
indicated by the polarity marks( / ).
• When inserting the batteries, make sure
not to damage the springs on the batteryis
( ) terminals. This can cause batteries
to leak or overheat.
• Do not heat batteries, disassemble them,
or throw them into flames or water.
• Batteries may have different voltages, even
if they look similar. Do ot use different
kinds of batteries together.
• To prevent leakage of battery fluid, remove
the batteries if you do not plan to use the
remote control for a long period of time (1
month or more). If the fluid should leak,
wipe it carefully off the inside of the case,
then insert new batteries. If a battery
should leak and the fluid should get on
your skin, flush it off with large quantities of
water.
• When disposing of used batteries, please
comply with governmental regulations or
environmental pubic institution's rules that
apply in your country/area.
Warning
• Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.
• The batteries included with the unit are to
check initial operations; they may not last
over a long period. We recommend using
alkaline batteries that have a longer life.
Before you start