Black plate (25,1)
Installing the GPS antenna
CAUTION
Do not cut the GPS antenna lead to shorten
it or use an extension to make it longer. Alter-
ing the antenna cable could result in a short
circuit or malfunction and permanent da-
mage to the navigation system.
Installation notes
!
The antenna should be installed on a level
surface where radio waves will be blocked
as little as possible. Radio waves cannot be
received by the antenna if reception from
the satellite is blocked.
Dashboard
Rear shelf
!
When installing the GPS antenna inside
the vehicle, be sure to use the metal sheet
provided with your system. If this is not
used, the reception sensitivity will be poor.
!
Do not cut the accessory metal sheet. This
would reduce the sensitivity of the GPS an-
tenna.
!
Take care not to pull the antenna lead when
removing the GPS antenna. The magnet at-
tached to the antenna is very powerful, and
the lead may become detached.
!
Do not paint the GPS antenna, as this may
affect its performance.
Parts supplied
GPS antenna
Metal sheet
<CRD4732-A>25
En
25
English
Section
03
Installation
