AVIC-X930BT/XNUC
147
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7. DISASSEMBLY
2
3
4
While the photograph shown is slightly different from this model in shape, the disassembly procedure is the same.
-
Removing the Monitor Assy (Fig.1, 2, 3)
Fig.1
Remove the four screws. (Fig.1)
Remove the two hooks,
and then lay the Monitor Assy on the front. (Fig.1)
Disconnect the two FPC
and then remove the Monitor Assy.(Fig.3)
Remove the two hooks. (Fig.2)
Fig.2
Fig.3
When unplugging the Coaxial Jumper, make sure to use jig GGF1539.
If the antenna cable is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.
-
How to Remove the Coaxial Jumper
When unplugging Coaxial Jumper, hook the point of jig GGF1539 on the lid of Coaxial Jumper
and vertically draw out along with the engagement axis of connector.
-
How to Attach the Coaxial Jumper
For inserting Coaxial Jumper, adjust cord assy with the engagement axis of connector and insert it as vertically
as possible.
Do not insert the Coaxial Jumper in extreme slant, as the connector might suffer damage.
Connector
Coaxial Jumper
GGF1539
1
2
Monitor Assy
1
1
2
3
3
4
4
1
1
Summary of Contents for AVIC-F930BT
