p
Different settings can be stored for each
video source.
p
The same setting is automatically applied
for the following grouping.
!
DVD-V
and
DivX
p
When viewing videos, select an appropriate
wide screen mode that matches its original
aspect ratio to view it comfortably.
p
Remember that use of this system for com-
mercial or public viewing purposes may
constitute an infringement on the author
’
s
rights protected by the Copyright Law.
p
The followings are always viewed at
“
Full
”
.
!
Map screen
!
Rear view camera image
!
Screen of an application available for
Advanced App Mode
Setting the rear output
The navigation system
’
s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
“
Rear SP
”
to
“
Sub. W
”
, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
“
Full
”
).
p
Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
p
“
Rear SP
”
can be set only when the source
is selected to
“
Off
”
.
p
This product is not compatible with the wir-
ing that the subwoofer is directly con-
nected to rear speaker leads. Always use
the setting with
“
Full
”
.
1
Display the
“
AV System Settings
”
screen.
=
For details, refer to
2
Touch [Rear SP].
Each touch of [
Rear SP
] changes the settings
as follows:
!
Full
(default):
When no subwoofer is connected to the
rear output, select
“
Full
”
.
!
Sub. W
:
When a subwoofer is connected to the rear
output, select
“
Sub. W
”
.
Switching the preout setting
CAUTION
Ensure the output setting of
“
Preout
”
is the same
as the speaker connected.
You can switch the output setting of the preout
of this navigation system to the subwoofer or
rear speaker.
p
“
Preout
”
can be set only when the source
is selected to
“
Off
”
.
p
If you set
“
Rear SP
”
to
“
Sub. W
”
, you can-
not conduct the setting of
“
Preout
”
.
1
Display the
“
AV System Settings
”
screen.
=
For details, refer to
2
Touch [Preout].
Each touch of [
Preout
] changes the settings
as follows:
!
Sub. W
(default):
When a subwoofer is connected to the pre-
out outputs (SWL, SWR), select
“
Sub. W
”
.
!
Rear
:
When rear speaker is connected to the pre-
out outputs (SWL, SWR), select
“
Rear
”
.
Switching the muting/
attenuation timing
You can mute the AV source volume or attenu-
ate the output signal.
Engb
154
Chapter
27
Customising preferences