Pioneer AVIC-F60BT, Installation Manual

Page: 21 / 32

Black plate (21,1)
Installing this product
Installation notes
!
Do not install this product in a position
where the opening of the LCD panel is ob-
structed by any obstacles, such as the
gearstick. Before installing this product, be
sure to leave sufficient space so that the
LCD panel does not obstruct the gearstick
when it is fully opened. This may cause in-
terference with the gearstick, or a malfunc-
tion of the mechanism of this product.
!
Do not install this product in places subject
to high temperatures or humidity, such as:
—
Places close to a heater, vent or air con-
ditioner.
—
Places exposed to direct sunlight, such
as on top of the dashboard.
—
Places that may be exposed to rain,
such as close to the door or on the vehi-
cle
’
s floor.
!
Install this product in an area strong en-
ough to bear its weight. Choose a position
where this product can be firmly installed,
and install it securely. If this product is not
securely installed, the current location of
the vehicle cannot be displayed correctly.
!
Install this product horizontally on a sur-
face within 0 to 30 degrees tolerance (with-
in 5 degrees to the left or right). Improper
installation of the unit with the surface
tilted more than these tolerances increases
the potential for errors in the vehicle
’
s loca-
tion display, and might otherwise cause re-
duced display performance.
30°
5° 5°
!
When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
Leave ample
space
5 cm
5 cm
!
The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
!
The semiconductor laser will be damaged
if it overheats, so don
’
t install this product
anywhere hot
—
for instance, near a heater
outlet.
<CRB4352-A>21
Engb
21
Section
03
Installation
Installation