10
9
Connecting the System
ENG/MASTER 96
Connecting the power cord (1)
Speed detection circuit lead
Vehicle injection computer
Connection method
Connector
Pass the extension cord and
the lead for the speed detec-
tion circuit through this hole.
Clamp firmly with
needle-nosed pliers.
Close the cover.
Note:
The position of the speed
detection circuit depends on the
vehicle model. For details, consult
the relevant documents from
Pioneer. When making connec-
tions for a model not listed in
those documents or for which con-
nection to the speed detection cir-
cuit is too difficult, connect the
separately sold ND-PG1 speed
pulse generator to the pink lead.
Note:
The position of the hand-
brake switch depends on the vehi-
cle model. For details, consult the
vehicle owner’s manual or dealer.
Pink (CAR SPEED SIGNAL INPUT)
The mobile navigation system is connected here to detect the distance
the vehicle travels. Always connect the vehicle’s speed detection cir-
cuit or the ND-PG1 speed pulse generator, sold separately. Failure to
make this connection will increase errors in the location display.
WARNING: IMPROPER CONNECTION MAY RESULT IN
SERIOUS DAMAGE OR INJURY INCLUDING ELECRICAL
SHOCK, AND INTERFERENCE WITH THE OPERATION OF
THE VEHICLE’S ANTILOCK BRAKING SYSTEM, AUTO-
MATIC TRANSMISSION AND SPEEDMETER INDICATION.
Lightgreen
Used to detect the ON/OFF status of the handbrake. This lead must
be connected to the power supply side of the handbrake switch.
If
this connection is made incorrectly or omitted, certain functions
of your navigation system will be unusable.
Connection method
Clamp the handbrake switch
power supply side lead.
Clamp firmly with
needle-nosed pliers.
Power supply side
Ground side
Handbrake switch
CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 10
