English
27
Chapter
57
En
Do not directly connect the yellow lead of
this product to the vehicle battery. If the
lead is directly connected to the battery,
engine vibration may eventually cause
the insulation to fail at the point where
the wire passes from the passenger
compartment into the engine compart-
ment. If the yellow lead’s insulation tears
as a result of contact with metal parts,
short-circuiting can occur, resulting in
considerable danger.
It is extremely dangerous to allow cables
to become wound around the steering
column or shift lever. Be sure to install
this product, its cables, and wiring away
in such so that they will not obstruct or
hinder driving.
Make sure that the cables and wires
will not interfere with or become caught
in any of the vehicle’s moving parts,
especially the steering wheel, shift lever,
parking brake, sliding seat tracks, doors,
or any of the vehicle’s controls.
Do not route wires where they will be
exposed to high temperatures. If the
insulation heats up, wires may become
damaged, resulting in a short circuit or
malfunction and permanent damage to
the product.
Do not shorten any leads. If you do, the
protection circuit (fuse holder, fuse resis-
tor or filter, etc.) may fail to work properly.
Never feed power to other electronic
products by cutting the insulation of the
power supply lead of this product and
tapping into the lead. The current capac-
ity of the lead will be exceeded, causing
overheating.
Before installing this product
Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
To avoid shorts in the electrical system,
be sure to disconnect the (–) battery
cable before installation.
To prevent damage
WARNING
Use speakers over 50 W (output value)
and between 4
:
to 8
:
(impedance
value). Do not use 1
:
to 3
:
speakers
for this unit.
The black cable is ground. When install-
ing this unit or power amp (sold sepa-
rately), make sure to connect the ground
wire first. Ensure that the ground wire is
properly connected to metal parts of the
car’s body. The ground wire of the power
amp and the one of this unit or any other
device must be connected to the car
separately with different screws. If the
screw for the ground wire loosens or falls
out, it could result in fire generation of
smoke or malfunction.
Ground wire
Metal parts of car’s body
POWER AMP
Other devices
(Another electronic
device in the car)
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on
this product.
This product cannot be installed in a
vehicle without ACC (accessory) position
on the ignition switch.
ACC ON
S
TA
RT
O
FF
ON
S
TA
RT
O
FF
ACC position
No ACC position
To avoid short-circuiting, cover the
disconnected lead with insulating tape.
It is especially important to insulate all
unused speaker leads, which if left uncov-
ered may cause a short circuit.
For connecting a power amp or other
devices to this product, refer to the
manual for the product to be connected.
■
Notice for the blue/white lead
When the ignition switch is turned on
(ACC ON), a control signal is output
through the blue/white lead. Connect to
an external power amp’s system remote
control terminal, the auto-antenna relay
control terminal, or the antenna booster
power control terminal (max. 300 mA
12 V DC). The control signal is output
through the blue/white lead, even if the
audio source is switched off.
