9
Inserting a disc
X3800BHS
X2800BS
X1800S
1 Insert a disc into the disc-loading slot.
Ejecting a disc
X3800BHS
X2800BS
X1800S
1 Press button to eject a disc.
Plugging and unplugging a USB stor-
age device
p
This product may not achieve optimum performance with
some USB storage devices.
p
Connection via a USB hub is not possible.
p
A USB cable is required for connection.
1 Pull out the plug from the USB port of the USB
cable.
2 Plug a USB storage device into the USB cable.
2
1
1
USB cable
2
USB storage device
Check that no data is being accessed before pulling out the
USB storage device.
On first-time startup
1 Start the engine to boot up the system.
The “
Select Program Language
” screen appears.
p
From the second time on, the screen shown will differ
depending on the previous conditions.
2 Touch the language.
3 Touch
.
The “
Speaker Mode Settings
” screen appears.
4 Touch the speaker modes.
Standard Mode
4-speaker system with front and rear speakers, or a
6-speaker system with front and rear speakers and
subwoofers.
Network Mode
3-way system with a high range speaker, middle range
speaker and subwoofer (low range speaker) for reproduction
of high, middle and low frequencies (bands).
WARNING
Do not use the unit in standard mode when a speaker system
for 3-way network mode is connected to this unit. This may
cause damage to the speakers.
5 Touch [
OK
].
The “
Smartphone Setup
” screen appears.
6 Touch the item.
Refer to
Information on the connections and functions for
each device
on page 18
7 Touch
.
The top menu screen appears.
p
Once the speaker mode is set, the setting cannot be
changed unless this product is restored to the default
settings. Restore the default settings to change the speaker
mode setting.
Refer to
Restoring the default settings
on page 52
Switching the speaker mode
To change the speaker mode, you need to restore this product to
the default settings.
1 Restore the default setting.
Refer to
Restoring the default settings
on page 52
injury in the event of an accident.
CAUTION
Do not open or close the LCD panel by force. It may cause
a malfunction.
Do not operate this product until the LCD panel has
completely opened or closed. The LCD panel may stop at
that angle for safety.
Do not place a glass or can on the open LCD panel.
Adjusting the LCD panel angle
X5800BHS
X4800BS
1 Press the button.
2 Touch
or
to adjust the angle of the
LCD panel.
3 Touch .
Returns to the previous screen.
Inserting/ejecting/connecting
media
CAUTION
Do not insert anything other than a disc into the disc-loading
slot.
Inserting and ejecting a disc
Inserting a disc
X5800BHS
X4800BS
1 Press the button.
2 Touch
to open the LCD panel.
3 Insert a disc into the disc-loading slot.
Ejecting a disc
X5800BHS
X4800BS
1 Press the button.
2 Touch
to open the LCD panel.
3 Remove the disc, and press the button.
9
< CRD4924-A >
Basic operation
Basic operation
