7
En
En
g
lis
h
Remove the insulation sheet before use.
WARNING
•
Do not ingest the battery, Chemical Burn Hazard.
(The remote control supplied with) This product contains a coin/button cell battery. If the coin/
button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to
death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep it away from
children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
•
Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine,
fire or the like.
CAUTION
•
Remove the battery if the remote control is not used for a month or longer.
•
There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type.
•
Do not handle the battery with metallic tools.
•
Do not store the battery with metallic objects.
•
If the battery leaks, wipe the remote control completely clean and install a new battery.
•
When disposing of used batteries, please comply with governmental regulations or environmental
public institutions’ rules that apply in your country/area.
•
“Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California, U.S.A.)”
Point the remote control in the direction of the front panel to operate.
Preparing the remote control
Using the remote control
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (-) poles orientated properly.
NOTE
The remote control may not function properly in direct sunlight.
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator.
1
Start the engine to boot up the system.
The [Speaker Mode Settings] screen appears.
2
Touch the speaker modes.
[
Standard Mode
]
4-speaker system with front and rear speakers, or a 6-speaker system with front and
rear speakers and subwoofers.
[
Network Mode
]
3-way system with a high range speaker, middle range speaker and subwoofer (low
range speaker) for reproduction of high, middle and low frequencies (bands).
WARNING
Do not use the unit in standard mode when a speaker system for 3-way network mode is
connected to the unit. This may cause damage to the speakers.
3
Touch [OK].
Initial Legal Disclaimer screen appears.
4
Touch [OK].
The top menu screen appears.
NOTE
Once the speaker mode is set, the setting cannot be changed unless this product is restored to the
default settings. Restore the default settings to change the speaker mode setting (page 43).
To change the speaker mode, you need to restore this product to the default settings.
1
Restore the default setting (page 43).
You can operate this product by touching the keys on the screen directly with your
fingers.
Starting up the unit
Switching the speaker mode
Using the touch panel
