Pioneer AVH-8400BT, Operation Manual

Page: 52 / 88

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the RGB Input
You can switch the setting of RGB input.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch RGB Input on the system menu
to turn iPhone or NAVI.
Note
If you use Advanced App Mode, set to iPhone .
Setting the App sound mixing
You cannot turn on or off Mixing when this
unit is playing a song of iPod.
The sound of application during Advanced
App Mode can be adjusted.
Enable this setting when you want to mix the
App sound with the sound from a built-in
source (such as the radio). The volume of the
App sound can be selected from 3 levels.
1 Display the system menu.
Refer to Introduction of menu operations on
page 44.
2 Touch App sound mixing on the System
menu to select desired setting.
OFF
(off)
—
Low (low)
—
Mid (mid)
—
High
(high)
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Full ) or subwoofer
( Subwoofer ) connection. If you switch the
rear output setting to
Subwoofer
, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (
Full ).
1 Turn the unit off.
Refer to Basic operations on page 9.
2 Press HOME to switch to the HOME dis-
play.
3 Touch System key.
System menu is displayed.
4 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
#
When no subwoofer is connected to the rear
output, select Full (full-range speaker).
#
When a subwoofer is connected to the rear
output, select
Subwoofer
(subwoofer).
Notes
!
Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to
Using subwoofer output on
page 46).
!
Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
En
52
Section
13
Menu operations