Pioneer AVH-5450DVD, Owner'S Manual

Page: 35 / 68

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 27.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 27.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit's rear speaker leads can be con-
nected with full-range speaker (
Full ) or sub-
woofer ( Subwoofer ). If you switch the rear
speaker setting to Subwoofer , you can con-
nect the lead directly to a subwoofer without
using an auxiliary amp.
!
When no subwoofer is connected to the
rear output, select
Full (full-range speaker).
!
If the rear speaker leads are connected
with a subwoofer, select
Subwoofer (sub-
woofer).
This unit's rear output (RCA rear output) can
be used for subwoofer (
Subwoofer
) or rear
(
Rear Speaker
) connection.
!
When no subwoofer is connected to the
rear output, select
Rear Speaker (Rear).
!
When a subwoofer is connected to the rear
output, select
Subwoofer (subwoofer).
1 Turn the unit off.
Refer to Basic operations of this unit on page
11.
2 Display the system menu.
Refer to Introduction of menu operations on
page 27.
3 Touch Rear Speaker on the system
menu.
Rear Speaker
items are displayed.
#
Rear Speaker
–
Adjust the rear speaker con-
nection.
#
Preout
–
Adjust the preout connection.
4 Touch Rear Speaker item to select the
desired rear speaker setting appears.
#
Rear Speaker can be set Full or Subwoofer .
#
Preout can be set Subwoofer or Rear .
Notes
!
Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to
Using subwoofer output on
page 29).
!
If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
Setting the FM tuning step
!
The tuning step remains at 50 kHz during
manual tuning.
1 Turn the unit off.
Refer to Basic operations of this unit on page
11.
2 Display the system menu.
Refer to Introduction of menu operations on
page 27.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
Setting the AM tuning step
%
Touch AM Step on the initial menu to
select the AM tuning step.
Touching AM Step will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
En
35
Section
10
Menu
operations
Menu operations