Pioneer ANH-P9R, Installation Manual

Page: 24 / 160

Calibration
Calibration
After commissioning , a calibration journey is
required. During the journey, the speedometer
signal is adapted to the vehicle-specific data
and the gyro sensors are adapted to the installa-
tion position of the unit.
The distance to be covered depends on the type
of vehicle and the local conditions.
Note
• The navigation system is only ready for opera-
tion on completion of the calibration journey.
The main navigation menu is displayed. Final
precision is only achieved after a further jour-
ney (calibration status 3).
1 In service garage mode, select
CALIBRA-
TION RIDE
using the rotary stick and press to
confirm.
The calibration status (e.g.
STATUS: 2
) and the
type of locationing (e.g.
3D
) are displayed. After
completing calibration, the street in which you
are currently driving is displayed (provided that
it is digitised) instead of
WHEEL
and
REVERSE
.
Deleting the calibration
If the navigation system is removed from one
vehicle and installed in another vehicle, it must
be calibrated. However, to do so, the current
calibration data must be deleted.
1 In service garage mode, select
CALIBRATION
using the rotary stick and
press to confirm.
2 Using the rotary stick, select
DELETE
and
press to confirm.
The calibration is deleted and the unit returns to
service garage mode.
Calibration setting
Note
• Calibration settings should only be made
when the values to be entered are known. The
unit cannot make correct route calculations if
incorrect values are entered.
1 In service garage mode, select
CALIBRATION
using the rotary stick and
press to confirm.
Setting the Navigation
En 24