Controls and displays
03
11
En
English
Français
Deutsch
Nederlands
Italiano
Español
Remote control
1
AMP
Switches the amplifier between standby and
on.
2
Input selector buttons
Press to select an input source. These select
the component connected to the
corresponding input on the rear panel.
3
SOUND RETRIEVER
Press to switch the Sound Retriever on/off
(page 12).
4
TONE/BAL controls
Use to adjust the tone and balance (page 12).
5
/–
Use to set the listening volume.
6
MUTE
Mutes/unmutes the sound.
7
DIMMER
Dims or brightens the display (or switches the
backlight off).
8
DIRECT
Press to access Direct listening (page 12).
9
CD PLAYER control buttons
Use to control Pioneer CD player.
10 TUNER control buttons
Use to control Pioneer tuner.
Using the remote control
Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit’s remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a fall
off in the operating range of the remote.
1
7
8
9
2
3
4
6
5
10
INTEGRATED AMPLIFIER
AMP
DIMMER
CD
TAPE
PHONO
TUNER
AUX
USB
L
R
VOLUME
MUTE
CD PLAYER
TUNER
BAND
PRESET
PRESET
TONE/BAL
SOUND
RETRIEVER
DIRECT
A9MK2_SYXCN5.book 11 ページ ２００９年４月３日 金曜日 午後７時１０分
