7
8.
Coin Door Installation
PinPAC4:
Remove validator blank plate by unbolting the
four nuts as shown. Note: Save the spacers. The
spacers are used to properly space the length of
the screw.
Insert the PinPAC4 plate as shown below.
Position the ESD ground wire (the green wire)
on the threaded stud. Fasten with the original
hardware.
Insert the end of the RJ45 Cable into the
connector on the PinPAC4 front control panel as
shown.
Route the cable into the cable harness clip
behind the door as shown. Test the door to
make sure it closes properly. Adjust as
necessary.
