background image

Button puts the unit directly into 

Dehumidifying

operation at the original factory humidity setting
(60% RH).  Pressing the Power Button again will
stop the unit from operating.

2.   Continue Button: 

Pressing this button while the

unit is operating will put the unit into

Continuous Dehumidifying

mode.

3.   Hu Button: 

Pressing this button while

the unit is operating will increase the humidity
setting.  The range is from 35%RH to 80%RH.

4.   Humidity - Button: 

Pressing this button while

the unit is operating will decrease the humidity
setting.  The range is from 80%RH to 35%RH.

5.   Turbo Fan Button:

Pressing this button puts the

fan speed on high.

6.   Normal Fan Button:

Pressing this button puts

the fan speed on low.

7.   Power Indicator: 

At first when connecting to

power, the Power Indicator will flash slowly.
Once unit is operating it will stay on, and turn off
when unit is off.

8.   Continue Indicator: 

Lights up when unit is in

Continuous Dehumidifying

mode.

9.   Full Indicator: 

Lights up when Water Tank is

full; the unit then will stop operating.

10. Turbo Indicator:

Lights up when the Turbo

Button is pressed and the fan is on high.

11.  Normal Indicator:

Lights up when the Normal

Fan Button is pressed and the fan is on low.

NOTE:

This unit has an automatic shut-off.  If the

bucket is full or is not replaced correctly, the unit will
not start and will display a “P2” warning.  Please be
sure bucket is not full or inserted correctly. 

For Continuous Drainage:

If a drain is located nearby, a 1/2” ID hose (sold
separately) can be connected to the unit for continu-
ous draining.
1.  On the rear on the unit, carefully remove the rub-

ber plug from the drain hole (see Figure 2 on
page 3) and slide the drain hose into the drain
hole.

2.  Remove the Water Tank then connect the water

hose to the connector located above the water
tank to the left.

3.  Be sure the hose has no bends or kinks.
4.  Place the other end of the hose into a suitable

drainage facility, and 

replace Water Tank

.

NOTE: 

The drain is not pressured; it is gravity assist-

ed.  Please be sure to note that the end of the hose
in the draining facility MUST be below the connector
in the unit. Any inclination of the drain hose will
cause the drain hose to back up to the unit and
cause a leak!

The Control Panel:
1.   Power Button:

Power indicator blinks slowly

when the unit is plugged in.  Pressing the Power 

Figure 3: Control Panel

1

2

3

4

5

6

7

8

9

10

11

Operation (cont.)

FOR BEST RESULTS:  

CLEAN AIR FILTER EVERY

TWO WEEKS.

Residential

Dehumidifier

Page 4

Pinnacle Products International, Inc.  Residential Dehumidifier Owners’ Manual

Summary of Contents for TT-40P-DH









Reviews: