Pima Hunter-Pro 8144, Installation Manual

Page: 52 / 116

52 Programming the System
Hunter-Pro Series & Captain 8 Installation Guide
Copying options
Par. Option
T Copy the zone's type
C Copy the zone's characteristics
P Copy the zone’s partitions
6.5
Key 3
: Communication
See the menu screens in section ‎B.2, on page 94.
6.5.1 MS 1 Options
6.5.1.1 Protocol & station number
Set Monitoring Station #1 PSTN protocol and radio station number. The PSTN protocol is
made of a set of 2 numbers, marked “A” & “B” in the above image. These “A” & “B” match the
corresponding columns in the codes table, on page 88. The
default PSTN format “0 230” is
Ademco ContactID
©
“T” is the radio station number (given by the Monitoring Station).
If a radio receiver is not
installed, leave the default value T=0
6.5.1.2 Reports selection
Each parameter in this screen represents an event. Select which
event will be reported to the Monitoring Station. See the following
table for details.
Char. Alarm/Event
A Burglary alarms
A Anti-Mask alarms
1 Special Burglary 1 alarms
2 Special Burglary 2 alarms
P Panic alarms
F Fire alarms
D Duress/Hold-up alarms
M Medical alarms
O Arming/Disarming by telephone
L Faults
T Tests
W Remote test request: when the system is Armed, calling the control panel
and waiting for 2 rings, will trigger a test report.
I Entering the Technician code
R Enabling this parameter wiil couse the control panel to report on Open/Close
events only by the radio
To save, press [ENTR].
A A 1 2 P F D M O L T W I R
+ + + + + + + + + + + - + + 1