FORCE Alarm System User Guide
22
PIMA Electronic Systems
Zone
Description
No., steady on Closed zone (normal mode)
No., flashing Open zone - you must close or bypass to arm.
No. missing
The zone is permanently disabled by the technician
A
The zone is alarming now, or was violated when the alarm system was armed.
B
The zone has been bypassed by a user, or during auto arming.
C
Chime zone (door or window)
F
Zone fault. May indicate on burglary setup - call service immediately!
M
Anti-mask alarm; triggered when a wireless anti-mask detector is blocked
(masked) with a material such as paper, tape, film, or spray. The zone is
alarming now, or was violated when the alarm system was armed. Remove the
blocking material or call service immediately - may indicate on burglary setup!
O
Armed zone (24H zone, or all the allocated partitions of the zone are armed)
T
Test mode (set by the technician. The zone will not trigger the alarm). The
zone will be reinstated automatically after few days.
S
Polling loop short
9.3
Armed Partitions
User Menu
System Options
Armed Partitions
View the numbers and names of the partitions that are currently armed. Only the keypad’s
allocated partitions are displayed.
9.4
Time and Date
User Menu
System Options
Date and Time
The system time must be set after a prolonged power failure (when the backup battery is
discharged). If the alarm system is connected to PIMA cloud, time can be automatically updated
(see below). Make sure system time is always accurate:
Auto-Arming and Disarming Window of
Time are time-based, and so is the event memory.
Parameter
Description
Time
Set the current time in hh:mm
Date
Set the current date in dd:MM
Year
Set the current year in 2 digits
Cloud auto-update If the alarm system is connected to PIMA cloud, time will automatically
be updated by the cloud.
Day
Set automatically
9.5
Chime Zones
User Menu
System Options
Chime Zones
Chime is a feature, in which the keypad buzzer sounds a series of beeps when a protected door
or window is opened. The chime is active only while the alarm system is disarmed.
1)
Chime Active/Inactive: globally set if the chime is active or not.
2)
Set per Zone: press # or * to select a zone, and press for the chime to be active.
