Commissioning
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 75
7.3.2
Tool detection
All tool shapes are permitted in principle (but please refer to the warnings in the section en-
titled "Tool shapes", under "Safety").
In TOOL CHANGE operating mode, the PSENvip detects the contour of the tool and as-
signs it to a tool class.
Assignment to a tool class depends on
}
Compliance with the requirement from EN 12622, whereby the protected field must safe-
guard areas lying 15 mm before the front bending line.
}
Full or partial detection of the upper tool via the protected field.
>15 mm
1
2
3
<15 mm
H3
V2
H2
V3
V1
H1 B1
Fig.: Classification of tools into tool classes
