Installation
Operating Manual PSENvip RL D P Set
1001641-EN-09
| 51
5.2
Install transmitter and receiver
}
Fastening kits for the transmitter and receiver are available as accessories (for order no.
see Chapter 11, "Technical Details").
}
The fastening kit consists of an adapter plate and adjustment plate with a slot nut. The
bracket on the upper die must have a corresponding groove in which to insert the slot nut
(see Fig. 5-1).
14+0,3
7+0,3
15
+0,2
8,3
+0,2
1
17+0,5
(4x) ø15
(4x) ø8.4
(32)
5
(71.5)
115
35
35
27
A-A
B
B
Fig.: Dimensions of adapter plate with groove, dimensions in mm
}
Both the transmitter and receiver are installed in the same way. Only the dimensions of
the adjustment plates for the transmitter and receiver are different.
To install the system, proceed as follows:
}
Fasten the adjustment plate as shown in the diagram below. Ensure that the flat washers,
spring washers and nuts are attached in the right order.
