PSEN cs4.2a
Operating Manual PSEN cs4.2a
1003575-EN-08
| 25
Actuator cs3.1 low profile
WARNING!
Loss of the manipulation protection by inadequate environmental con-
ditions
The loss of the manipulation protection can allow manipulation of the inter-
locking device and it may lead to serious injury or death.
– Make sure that the actuator has no direct or repetitive contact with
materials such as methyl ethyl ketone (MEK), petrol or isopropanol.
}
The actuator is secured against unauthorised removal, and against contamination by the
sealing. The seal should be regarded as equivalent to using permanent fastenings in ac-
cordance with EN ISO 14119.
}
By removing the actuator, the actuator will be destroyed.
}
The actuator’s adhesive force on the materials aluminium, stainless steel, polycarbonate
and glass was checked. For deviating surface materials check the adhesive force on the
surface.
}
After a cure time of 24 hours, 90 % of the final adhesive force are achieved. The harden-
ing must take place at min. 20 °C. With lower temperatures the cure time is clearly exten-
ded.
}
No continuous force must affect the actuator.
