PNOZ X10.1
Operating Manual PNOZ X10.1
20005-EN-10
| 14
Status indicators
LEDs indicate the status and errors during operation:
LED on
POWER
Supply voltage is present.
CH.1 IN
Channel 1 input circuit is closed.
CH.2 IN
Channel 2 input circuit is closed.
K1
Relay K1 (channel 1) is in the operating position.
K2
Relay K2 (channel 2) is in the operating position.
K3
Start button is closed
.
Faults – Interference
}
Earth fault: The supply voltage fails and the safety contacts open. Once the cause of the
respective fault has been rectified and the supply voltage is switched off for approx.
1 minute, the unit is ready for operation again.
}
Contact malfunctions: If the contacts have welded, reactivation will not be possible after
the input circuit has opened.
}
LED "POWER" does not light: Short circuit or no supply voltage.
Dimensions in mm
121 (4.76")
75 (2.95")
87 (3.42")
90 (3.54")
