IMPORTANT FOR YOUR SAFETY!
Whenever you are handling or working with a lead-acid battery, consult your battery
owners’ manual for instructions and safety precautions.
COOLING FAN
Do not cover the cooling fan openings in order to ensure
enough cooling flow. Otherwise the charging current will
drop and the charging time will increase proportionally.
BATTERY TYPE
Use the charger for the defined battery type only,
(according to the parameters). If the charging profile does
not suit the battery type, the battery will not be charged
properly and the life time of the battery may be shortened.
GAS
Lead-acid batteries produce hydrogen-oxygen gases which
can be explosive and sulfuric acid that can cause severe
burns. Make sure working area is well-ventilated.
Cigarettes or any open fires or sparks may cause an
explosion. Keep all ignition sources away from the battery.
ACID
Battery acid can severely damage your eyes and skin. In
event of accident, flush with water and seek medical help
immediately. Use proper personal protective devices when
handling a damaged or leaking battery. Treat material used
to clean up a battery acid spill as hazardous waste.
TOXIC
SUBSTANCES
Batteries contain hazardous materials. Among others lead
and antimony are toxic substances. Waste lead-acid
batteries are hazardous waste and must be treated
according to the Battery Disposal Regulations.
Manufacturer:
Piktronik d. o. o.
Cesta k Tamu 17
SI - 2000 Maribor
-
Distributor:
10/2014
OPERATING INSTRUCTIONS
Battery Charger KOP602 / KOP1001
Battery chargers KOP602 and KOP1001 are modern fully automatic devices suitable
not only for charging but also for maintaining and monitoring the batteries. The
charger stores data about charging times and Ah charged. This data may be accessed
for further analysis.
The charger may be used as a stationary device or can be installed and operated in the
vehicles. The charger should be mounted horizontally. Any drilled holes or any
mechanical changes of the housing may damage the charger.
Your KOP battery charger was factory programmed for a specific battery type. Make
sure the charging profile suits your battery type. To change the charging profile for a
specific battery type, parameters may be programmed with a PC software package and
a programming interface. The programming parameters allow the chargers profile to
suit the battery type. Up to five charging phases can be programmed. The charging
voltages, currents, charging times, temperature compensation and other control
functions can be programmed. Please contact your dealer for further information.
When programming the charging profile always follow the battery manufacturer's
instructions regarding voltages, currents and charging times.
Read the operating instructions carefully before using the KOP Battery charger.
Note:
Please note, that new batteries reach the maximum capacity after multiple
charging cycles have been completed successfully. Old batteries often dont reach the
full capacity. This can cause the charging process not to end properly (example:
maximum charging time overflow).
TO START THE CHARGING PROCESS
Establish a safe connection between the battery and charger first. Then plug the
mains connector. This sequence must always be followed in this order. When
