7
Reset Function:
The Reset function removes all custom data settings stored in the Central Station and returns it to the original
factory default settings. Give careful thought before performing a Reset.
To avoid unintentional deletion of data, the Reset function is only activated by the following sequence:
Press the green Reset button (right) for 10 seconds, then release the button for 2 seconds, then press the
button for 10 seconds again. This starts the Reset process. The yellow LED (right) illuminates while data is
being deleted. This can take a few seconds. The LED remains illuminated until the procedure is completed.
Programming
:
The red and blue Track outputs on the back of the Central Station are used both for the main track and for
programming.
To avoid programming other locos, disconnect the Central Station from the main track and connect it to a
programming track, with no connection to the main track (Image 2). Any locos on this track will be programmed.
Operation of trains, switches and other items requires the PIKO Navigator.
For programming and read-out of decoders, it is helpful to switch the Central Station into "Emergency
Stop" mode (blinking red LED). In this mode, trains do not operate but the decoder can more reliably
receive and confirm data without the digital signal interference that trains and other devices can cause.
Important Safety Instructions:
• Please retain these Instructions as they include important information.
• Only connect the power supply (transformer) unit to a household electrical outlet once you have completed all
of the other connections.
• Never connect two or more Digital Central Stations with separate power supplies to the same track layout.
• Never connect more than one power supply (transformer) to a single Digital Central Station. Never connect
two or more Digital Central Stations to the same power supply.
• Clean the Digital Central Station only with a damp, soft cloth. Disconnect all cables before cleaning.
• Never insert wire from the Digital Central Station connecting cables into an electrical plug.
• Locate the Digital Central Station on a stabil, flat, easily accessible base, well-protected from the weather.
• Never open or make additional holes in the Digital Central Station housing. This voids the warranty.
• Unplug or shut off power to the power supply (transformer) when the train layout is unattended.
• Never leave your train layout operating without supervision.
• If the Digital Central Station needs repair, return it to the manufacturer or an authorized dealer.
• The Digital Central Station and related components are not toys and are not intended for use by children
under 14. These items are exclusively intended for operating model railway systems.
• Please instruct children that the Digital Central Station may only be used in accordance with its intended purpose.
• All electrical connections are to be made with the power supply disconnected or switched off.
• The electrical power source must have a circuit breaker or fuse sufficient to prevent a cable fire in the event of
a short circuit.
• Please maintain your Digital Central Station and related components in an environment that is protected as
well as possible from weather influences. The plastic covers of the Digital Central Station are only designed to
provide protection from mild, short-term incursion of moisture from above. Do not allow the Digital Central
Station and other electronic devices to be subjected to flooding, freezing, extreme heat or cold or other severe
weather conditions. Do not leave the Digital Central Station or other electronic devices unprotected outdoors.
This could cause damage and even serious safety hazards.
• The purchaser and operator are responsible for the safe connection, inspection and use of the Digital Central
Station and related devices!
* Item numbers for the American market only: #35021 Navigator, #35022 Wireless Receiver
** Not available in the American market
35010-90-7002.qxd
05.09.2016 13:10 Uhr Seite 7
