PIKA B801 REcharge, Operation Manual

Page: 29 / 35

26
8.3.2 Connection state messages:
“ Connection failed
network join failed ”
This message is displayed when the B801 has failed to connect to your Wi-Fi
network but not enough information is available to determine a specific
reason. In many cases this is due to poor receiver reception on the B801. Try
moving your Wi-Fi router closer to the B801.
“ Connection failed
authentication failed ”
This message will be displayed when the B801 is refused by your Wi-Fi router
because of an incorrect password. Re-enter your credentials to try again,
passwords may be case sensitive.
“ Connection failed
association failed ”
This message will be displayed when the B801 was able authenticate itself
with your network, but your router refused to let the B801 connect. This
usually means your router has been specifically configured to block the B801
from connecting. Check your router configuration and remove it from any
device block lists.
“ Connection failed
handshake failed ”
This message will be displayed when your router and B801 have failed to
exchange encryption information. This can be caused by data corruption due
to noise. Sources of this noise are microwave ovens, wireless phones, and
other sources of 2.4 GHz radio. If this happens repeatedly try moving your
Wi-Fi router closer to the B801.
“ Connection failed
Security mismat ch”
This message will be displayed if the B801 has been configured to use the
wrong type of Wi-Fi
security. If you manually selected “WPA” as your
network type, try using “WEP” instead. If you manually selected “WEP,” try
“WPA.”
“ Connection failed
no suitable AP found ”
This message will be displayed if the B801 was unable to find your network
after scanning. Double check that your network name is correct. If the
network name is correct, the B801 might be out of range of your Wi-Fi
network. Try moving the Wi-Fi router closer to the B801.
“C onnection temp lost
AP beacon timeout”
This message is displayed when the B801 has failed to receive the
“heartbeat” message that all Wi-Fi routers send. This can happen if your Wi-
Fi router is being reset, powered down, or is just beyond the signal range to
the B801. The B801 is still attempting to reconnect automatically when this
message is displayed.
“C onnection temp lost
Deauth received ”
This message indicates that your Wi-Fi router has told the B801 to
disconnect and re-authenticate itself. The B801 will attempt to reauthorize
and reconnect.
“ Connection temp lost
Disassociate received ”
This message indicates that your Wi-Fi router has told the B801 to reconnect.
The B801 will attempt to reconnect automatically.