PX200 V5 Manual
11
13/05/2022
10
Front Panel
Control
Type
Function
Power
Power On/Off
Overload LED
RED when the amplifier is disabled or in an overload state
Power LED
GREEN when the power is on
Input
Input
Input signal (
±
10V max, protected up to +/-20V)
Invert switch
Multiplies the input signal by -1 in the upward position
Gain switch
Adds additional gain to the input signal when in the upward position
Gain pot
Clockwise rotation increases the additional gain (up to a factor of 10)
Offset knob
Single turn potentiometer for DC offset
Offset pot
Multiple turn potentiometer for DC offset
Offset switch
Selects between the offset sources, or zero in the middle position
Voltage Limits
Limits the maximum negative and positive output voltage
Voltage Monitor
Output The measured output voltage, scaled by 1/20
Current Monitor
Output The measured output current, 1.5 V/A or 0.5 V/A (See Section 7)
Bias-
Output DC Bias connected to the negative high-voltage power supply rail
Bias+
Output DC Bias connected to the positive high-voltage power supply rail
Ground
Output Ground, connect to the load negative terminal
Output
Output Amplifier output, connect to the load positive terminal
LEMO 00 Output
Output EPL.00.250 connector, suits LEMO FFA.00.250 cable plug
LEMO 0B Output
Output FGG.0B.302 connector, suits LEMO FGG.0B.302 cable plug
BNC Output
Output Suits male BNC cable plug
DC Output Volt.
Display showing average output voltage
The mating connector for the 4-way screw terminal connector is OQ0432510000G.
