Pierce Mid-Mount Ascendant Aerial Tower, Manual, Page: 122 / 132

MAINTENANCE
5-16 / Mid-Mount Ascendant Aerial Tower
© 2021 Pierce Manufacturing Inc. All Rights Reserved.
5-10.2 Lubrication Chart
NOTE: Lubrication Intervals can be found within the various inspection tables. See
“Preventive
Maintenance Checks and Service”
on
page 5-8
.
Table 5-9: Lubrication Specifications
ITEM # QTY ITEM TO CHECK/SERVICE TYPE OF LUBRICANT
1 1 WATER SWIVEL IN BASKET
PIERCE MANUFACTURING CARTRIDGE
PN #1003040 or SYNCO SUPER LUBE
PN #41150
–or-
PIERCE MANUFACTURING
5 lb TUB PN #1003044 or SYNCO
SUPER LUBE PN #41050
–or-
PIERCE MANUFACTURING
30 lb PAIL PN #1003046 or SYNCO
SUPER LUBE PN #41030
2 4 WATERWAY BEARINGS
3 1 WATER SWIVEL, REAR OF LADDER
4 —
LADDER SECTION GUIDE PADS AND SLIDING
SURFACES
(Brush on outside and bottom of fly and mid
sections and inside of base and mid sections –
where guide pads rub.)
5 2 MONITOR(S)
PIERCE MANUFACTURING CARTRIDGE
PN #95-0903
– or –
EXXON NLG1 No. 2 GRADE GREASE WITH
MOLY
– or –
EQUIVALENT HEAVY DUTY No. 2 GRADE
GREASE WITH MOLY
6 2 LIFT CYLINDER PINS
7 1
TURNTABLE ROTATION BEARING - Pump
grease into the bearing while the bearing is being
rotated. Greasing is considered complete when
the grease overflows from the seal, forming a
light film which also serves as a seal.
(See
Figure 5-4
)
8 —
ROTATION BEARING TEETH (Brush on)
(See
Figure 5-5
)
9 2
STABILIZER BEAMS - Brush on bottom surface
of stabilizer beams and inside (top surface) of
torque box stabilizer housings.
10 6 STABILIZER PAD SWIVEL JOINTS
11 24 WIRE ROPE (CABLE) SHEAVE PINS
12 4 FRONT STABILIZER TIPPING CYLINDER
13 2
ROTATION GEAR BOX BEARING (on turntable)
(See
Figure 5-5
)
14 2
ROTATION GEAR BOX (on turntable)
(See
Figure 5-3
for specific instructions.)
API-GL5 80W90
15 1 HYDRAULIC SYSTEM RESERVOIR SEE HYDRAULIC OIL TAG ON RESERVOIR
16 4 WATERWAY TUBES
DEXTRON II AUTOMATIC TRANSMISSION
FLUID (OR EQUIVALENT)
17 — WIRE ROPE CABLES
LUBRIPLATE CHAIN AND CABLE FLUID
(OR EQUIVALENT)