Getting Started SIMRC 1050 Carrier, March 2008, MvB
page 1 of 2
Getting Started Documentation SIMRC 1050 Carrier
Hardware Installation
1. Install the SIMRC module 1080 first, refer SIMRC_1050D.pdf, page 3.
Before you insert the module, remove jumpers 5 / 6 / 7.
Set all its address switches to OFF.
Set jumpers to RS232.
2. Install the SIMRC modules 1 or 2 or 3 in any 1050 module connector 1 to 3
Before you insert the module, remove jumpers 5 / 6 / 7.
Set each module address to a unique address.
Set jumpers to I2C.
3. Connect a RS232 cable between PC COM port and the 1050 carrier with the
following wiring (refer diagram on page 4 of the SIMRC_1050D.pdf):
PC COM
1050 J5
TX (3) ------- (3)
RX
(2) ------- (2)
GND (5) ------- (5)
4. Connect 5 VDC power supply to the 1050 carrier, connector J6, refer diagram on
page 4 o f the SIMRC_1050D.pdf
5. Verify your settings with the SIMRC Soft Front Panel software.
