PICASO 3D Designer X, User Manual

Page: 18 / 68

POWER CONNECTION
17
Make sure all plastic locking clip parts and ties are removed. Take the printhead (PH)
into your hands and make sure that it moves freely. Plug the power cable into the power
adapter connector
against the stop then plug it into a power socket 220 V ± 15%, 50 Hz or
110 ± 15%, 60 Hz (in compliance with used electricity network standard).
Switch the power button to position 1 — the display and lighting turns on, the printer
beeps.
We recommend to keep the original box and pallet for further possible transportation of
the printer.
Never plug the Designer XL into a power socket without grounding
2
.
2
PrinterName has a heating components with a 220 V supply. Also it equipped a residual-current
device (RCD), which secure the safety only if the socket has a ground.