PIAGGIO X7 EVO 125ie, Manual

Page: 18 / 90

WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF THE VEHICLE IS SOLD, THE MASTER-HANDGRIP KEY (AS WELL AS THE
OTHER STARTER KEYS) AND THE «CODE CARD» MUST ALSO BE TRANS-
FERRED TO THE NEW OWNER.
Programming the immobilizer system (01_16)
Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
ISER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to « RUN ».
START PROCEDURE
Insert the «MASTER» key « A » into the ignition switch (in « OFF ») and turn it to
« ON ». After 1 - 3 seconds, turn the key to « OFF » again and pull it out.
INTERMEDIATE STAGE
After extracting the «MASTER» key « A », insert, within ten seconds, the key that is
going to be programmed « B » and turn it immediately to « ON ». After 1-3 seconds, turn
the key to « OFF » again and pull it out. In this way, a maximum of 3 keys can be
programmed by repeating the above procedure and keeping the indicated times.
18
1 Vehicle