PIAGGIO Liberty 50 Catalyzed 2019, Manual

Page: 33 / 62

03_09
Intakeplug (03_09)
Remove the cap of the transmission cover operating on the corresponding release
slots with a plain slot screwdriver. Wash the sponge in water and soap without re-
moving it from its seat.
Dry it with compressed air before refitting it taking care to do so at the correct angle.
CAUTION
WARNING!
SHOULD THERE BE ANY PROBLEMS WHEN ADJUSTING IDLE SPEED, IT MAY
BE NECESSARY TO ADJUST EXHAUST GASES (CO) TOO. TURN TO AN AU-
THORISED PIAGGIO SERVICE CENTRE TO CARRY OUT THESE OPERATIONS.
03_10
Checkingthebrakeoillevel (03_10, 03_11)
The brake fluid reservoir has a sight glass « A » made of transparent (located into the
hole drilled in the handlebar cover, right side); the quantity of liquid that can be seen
inside the sight glass indicates the quantity of liquid in the reservoir. When sight glass
«
A » is full, the level inside the reservoir exceeds the Min. mark. When it descends
even a little below the maximum level, the oil level is considered to be at Min. When
it is empty, the level is below the Minimum. The brake fluid level may fall due to wear
on the brake pads. Should the level be below the minimum, the Customer is advised
to contact an
Authorised Piaggio Service Centre for a thorough check of the braking
system. Should level be restored, follow the instructions below. Remove the front
handlebar cover following instructions indicated in the «Front headlight assembly»
section, then unscrew the 2 screws «
B », lift the cover of the brake fluid reservoir
« C » and add the necessary quantity of fluid (fluid must always be over the minimum
level).
Check these levels with the reservoir in a horizontal position, i.e. with the handlebars
straight and the scooter perfectly level.
33
3 Maintenance