PIAGGIO Beverly Tourer 125, Service Station Manual

Page: 45 / 278

This operation must be carried out with the engine
cold and following the procedure below:
1) Rest the scooter on the central stand and on a
flat ground.
2) Unscrew the cap/dipstick " A ", dry it with a clean
cloth and reinsert it, screwing it thoroughly .
3) Remove the cap/dipstick again and check that
the level is between the max. and min levels; top
up, if required.
The MAX level reference mark indicates the
amount of oil in the engine. If the check is carried
out after the vehicle has been used, and therefore
with a hot engine, the level line will be lower; in
order to carry out a correct check it is necessary
to wait at least 10 minutes after the engine has
been stopped, so as to get the correct level.
Characteristic
Engine oil
1.10 l
The oil should be topped up after having checked the level and in any case by adding oil without ever
exceeding the MAX. level .
Restoring the level between the MIN and MAX reference marks requires ~ 400 cm³ of oil.
Engine oil filter
The cartridge filter must be replaced every time the oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and oil drainage plug, screwing them up to the specified torque. Refit the new cartridge filter
being careful to lubricate the O-ring before fitting it. Change the engine oil.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the requirements of API SL, ACEA A3, JASO MA specifications
Oil pressure warning light
The vehicle is equipped with a warning light on the instrument panel that lights up when the key is turned
to the " ON " position. However, this light should switch off once the engine has been started.
Beverly 125
Maintenance
MAIN - 45