PIAGGIO Beverly Tourer 125, Service Station Manual

Page: 42 / 278

Hub oil
Check
-Stand the vehicle on its centre stand on flat
ground; - Remove the oil dipstick « A », dry it with
a clean cloth and put it back into its hole tighten-
ing it completely ; -Take out the dipstick checking
that the oil level reaches the dipstick bottom notch
(see figure); if the level is under the MAX. mark, it
needs to be filled with the right amount of hub oil.
-Screw up the oil dipstick again and make sure it
is locked properly into place.
The notches on the hub oil level dipstick, except
for the notch indicating the MAX level, refer to oth-
er manufacturer's models and have no specific
function for this model.
Replacement
-Remove the oil filler cap « A ». - Unscrew the oil
drainage plug « B » and drain out all the oil. - Screw
the drainage plug again and fill the hub with oil.
Recommended products
AGIP ROTRA 80W-90 rear hub oil
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Locking torques (N*m)
Hub oil drainage screw
15 ÷ 17 Nm
Maintenance
Beverly 125
MAIN - 42