PIAGGIO Beverly 300 i.e., Service Station Manual, Page: 47 / 333

SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Characteristic
Engine oil
1.3 l
Check
This operation must be carried out with the en-
gine cold and following the procedure below:
- Place the vehicle on its centre stand and on flat
ground.
- Make sure the adjustment of the rear suspension
is set to the minimum preloading position.
- Unscrew the cap/dipstick « A », dry it with a clean
cloth and reinsert it, by screwing it in complete-
ly .
-Remove the cap/dipstick « A » again and check
that the level is between the MAX and MIN marks.
top-up, if required.
If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the
level line will be lower; in order to carry out a cor-
rect check, wait at least 10 minutes after the en-
gine has been stopped so as to get the correct
level.
Oil top-up
The oil should be topped up after having checked the level and in any case by adding oil without ex-
ceeding the MAX level indicated on the cap/ dipstick.Restoring the level from MIN to MAX requires
approximately 400 cm³ of oil.
Engine oil filter
The cartridge filter must be replaced every time the oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing them up to the prescribed torque. Refit the new cartridge
filter being careful to lubricate the O-ring before fitting it. Change the engine oil.
Beverly Tourer 300 i.e.
Maintenance
MAIN - 47